Biostar U8598 Uživatelský manuál stáhnout pdf (Strana 33)

Mainboard Features

Serial ATA Chip - FastTrak 376

Step 1: Installing the Hard Drives

Important

If you wish to include your current bootable Serial or Parallel

ATA drive using the Windows NT 4.x, Windows 2000, or

Windows XP operating system on your FastTrak 376 Controller.

You MUST install the Windows NT4, 2000, or XP driver software

first onto this drive while it is still attached to your existing hard

drive controller.

1. Configure the jumpers of the Parallel ATA hard drive you’re preparing to connect

to the FastTrak 376 controller using the proper Master, Slave, or Cable-Select

settings. For more information, refer to the manual that came with your hard

drive.

2. Install all of the hard drives into the hard drive bays of your system, including

their power cables.

3. Attach the Parallel ATA cable to the hard drive(s) and to the Parallel ATA Port

connector on the FastTrak 376 controller. The colored edge of the cable

indicates pin 1. The blue cable connector attaches to the FastTrak 376.

4. Attach Serial ATA data cable to each hard drive. Then attach the other ends of

the cables to one of the Serial ATA ports on the FastTrak 376 controller. All of

the connectors are keyed so they will only attach one way.

Note

FastTrak 376 is a PCI Plug-n-Play (PnP) device. No changes are

necessary in the Motherboard CMOS Setup for resources or

drive types in most applications.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 54 55

Žádné komentáře

Biostar U8598 Uživatelský manuál Strana 33